| No |
Problem
/ Function |
Solution / Function |
 |
Other Brands |
| 1 |
Remaining Spangles |
Simply press Forward/Rev. Button |
Manually cutting by hand |
| 2 |
Precise Cutting |
No
need to adjust/align X,Y, and
Z position settings along the axes after works
|
Keep on adjusting the X, Y and
Z positions, setting them always manually. |
| 3 |
SPEED |
MAX
2,000 rpm
i-Metalex Spangle Attacher perform 1:1 operational
speed for spangle attachments. |
Average 650 ~ 750 rpm
Regardless to the speed of the embroidery machine,
the speed for the sequin device drops Average 650 ~
750 rpm when running for spangle attachments. |
| 4 |
After Electric Power-Off or Failure |
Automatically
return to the origin/reset.
No need of loss time
|
Manually setting for each head.
Too much of time loss. |
| 5 |
RESET / ORIGIN
|
On
occurrence of irregular cutting of spangles, simply
press RESET/ORIGIN Button, and it will be automatically
adjusted. |
Have to adjust one device at a
time by hand. |
| 6 |
ACCURACY / PRECISION
& OVER LOAD
|
Using
1,600 micro-pulse stepping motor means no over-duty
or over-load to the main machine, and provide the
most accurate and precise punching of each spangle. |
Using 400 pulse stepping motor causes noise,
inaccuracy & imprecision, and may fail to load its
work due to its low capacity of the performance. |
| 7 |
CONTROLLER |
Individual controller without alteration or
connection to the MAIN CPU.
|
Connecting with MAIN CPU causes serious problems
to the main CPU and the embroidery machine, such as
Fire, Burn-up on CPU |
| 8 |
Facility
|
On
any sides of needle base, Spangle Attacher can be
installed; Left front, Left hand side, Right front,
Right hand side.
Any kinds of threads, rayon, polyester, transparent
thread can be used.
|
Usually only on the one side the
device can be installed.
Only transparent thread can be used because of too
often thread cutting.
|
| 9 |
Up/Down of SPANGLE
ATTACHER
|
On
trimming, color/needle change, or
At the end of the work, it automatically moves up/down.
|
It's almost impossible to do up/down
function.
You could use the up/down function only for a short
period because the gear tooth will be spoiled after
a few month use. |
| 10 |
Positioning
During Work
|
After
trimming, it goes to jump function. |
Because of no up/down function,
you have to move the position of the devices by
the running stitch. |
| 11 |
Electric Power Supply |
Installation of Individual power supply provides the
safe environment to the operation with little load
on the embroidery machine. |
N/A |
